Mitsubishi — 3.8.2 Profiles

AH500 Hardware Manual 2. Function switch The function switch provides the following functions:  Setting the working mode (IN 0)  Setting the transmission speed of a DeviceNet network (DR 0~DR 1) Points for attention:  When the power supply is cut off, the functions are set. After the setting of the functions is complete, AH10DNET-5A can be supplied with power.  If AH10DNET-5A is running, changing the functions is unavailable.  Please use a slotted screwdriver to adjust the DIP switch with care, and do not scrape them. 3.

DeviceNet connector Pin Signal Color Description 1 2 3 4 5  AH10PFBM-5A 1 5 8 2 6 7 3 CON F 9 4 Profibus 10 3-62 DR 1 DR 0 Transmission speed OFF OFF 125 kbps OFF ON ON OFF 250 kbps 500 kbps ON ON Entering the extendable serial transmission speed mode IN 1 Reserved If the slave is disconnected, the previous I/O ON data is retained. If the slave is disconnected, the previous I/O OFF data is cleared. IN 0 If the slave is disconnected, the previous I/O data is cleared. 4 CAN H _ White Signal (positive pole) 3 SHIELD - It is connected to a shielded cable.

2 CAN L _ Blue Signal (negative pole) 1 V- Black 0 VDC Number Name Description 1 Model name Model name of the module 2 Seven-segment display Display 3 CONF interface The interface where the hardware configuration is downloaded