AH500 Hardware Manual 1. Setting a PROFIBUS node address The address knobs of AH10PFBS-5A are used for setting the node address of AH10PFBS-5A on a PROFIBUS-DP network. There are two address knobs. They are a knob corresponding to x16 0 , and a knob corresponding to x16 1 . The range for one address knob is 0~F. The range for setting the node address is described below. Example: If users need to set the node address of AH10PFBS-5A to 26 (decimal value), they have to turn the knob corresponding to x16 1 to “1”, and the knob corresponding to x16 0 to “A”. 26 (decimal value)=1A (hexadecimal value)=1x16 1 +Ax16 0 . Points for attention:
If users set the node address of AH10PFBS-5A when AH10PFBS-5A is not supplied with power, they have to power AH10PFBS-5A after the node address of AH10PFBS-5A is set. If users change the node address of AH10PFBS-5A when AH10PFBS-5A is powered, the change will not take effect immediately after the node address of AH10PFBS-5A is changed, and it will take effect after the users cut off the power supplied to AH10PFBS-5A and then power AH10PFBS-5A again. To prevent the address knobs on AH10PFBS-5A from being scratched, please carefully use a slotted screwdriver to rotate the address knobs on AH10PFBS-5A. 2.
Definitions of the pins in the PROFIBUS-DP port 3-64 1 x16 0 x16 Address Definition H’1~H’7D Valid PROFIBUS address H’0 or H’7E~H’FF Invalid PROFIBUS address Pin PIN name Description 9 5 6 1 1 -- N/C 2 -- N/C 3 RxD/TxD-P Sending/receiving data (P (B)) 4 -- N/C 5 DGND Data reference potential (C) 6 VP Supplying positive voltage 7 -- N/C 8 RxD/TxD-N Sending/receiving data (N (A)) 9 -- N/C