Mitsubishi — 3.8.2 Profiles

Chapter 3 Specifications for Products  AH10COPM-5A 1. CANopen communication connector A CANopen connector is connected to a CANopen network. Please wire AH10COPM-5A by using the connector attached to AH10COPM-5A. 2. Address knobs The address knobs on AH10COPM-5A are used to set the node address of AH10COPM-5A on a CANopen network. Setting range: 1~7F (0 and 80~FF can not be used.) Example: If the station address of AH10COPM-5A is 16#26, users have to turn the knob corresponding to x16 1 to position 2, and turn the knob corresponding to x16 0 to position 6. Points for attention:

 After the station address of AH10COPM-5A is changed, users have to power AH10COPM-5A 3-65 1 2 3 4 10COPM RUN ERROR 5 6 x16O Node Address x16N DR 2 DR 1 DR 0 IN 0 CAN+ SHLD CAN- GND 7 8 9 10 Number Name Description 1 Model name Model name of the module 2 Address knobs For setting an address 3 Function switch For setting a function 4 CANopen connector For a CANopen connection 5 RUN LED indicator Operating status of the module 6 ERROR LED indicator Error status of the module 7 Removable terminal block Terminals 8 Set screw Fixing the module 9 Label Nameplate 10 Projection Fixing the module Pin Signal Description 5 CAN+ 4 SHLD 3 CAN- 2 1 GND 5 - Reserved 4 CAN+ CAN H _ 3 SHLD Shielded cable 2 CAN- CAN L _ 1 GND 0 VDC NODE ADDRESS 1 x16 0 x16 Setting Description 1~7F Valid CANopen node address 0, 80~FF Invalid CANopen node address