Mitsubishi — 3.8.3 Dimensions

AH500 Hardware Manual again, otherwise the change will not take effect.  To prevent the address knobs on AH10COPM-5A from being scratched, please carefully use a slotted screwdriver to rotate the address knobs on AH10COPM-5A. 3. Function switch The function switch on AH10COPM-5A is used to set the communication speed at which AH10COPM-5A is connected to a CANopen network. There is a limit on the maximum communication distance to which a communication speed corresponds. Points for attention:  After users change the communication speed at which AH10COPM-5A is connected to a CANopen network, they have to power AH10COPM-5A again, otherwise the change will not take effect.

 To prevent the DIP switch on AH10COPM-5A from being scratched, please carefully use a slotted screwdriver to rotate the DIP switch on AH10COPM-5A. 3.8.3 Dimensions  AH10SCM-5A 35 103 10SCM ERROR RUN COM2 RS485 COM1 RS485 TR 1 ON COM1 OFF RX+ TX- TX+ D+ FG RX- GND FG D- GND 110 ON TR 2 OFF COM2 TX+ TX- RX+ RX- GND D+ D- GND FG FG Unit: mm 6 3-66 Maximum communication distance DR 2 DR 1 DR 0 I N 0 Communication DR 2 DR 1 DR 0 speed OFF OFF OFF 10 kbps 5000 m OFF OFF ON 20 kbps 2500 m OFF ON OFF 50 kbps 1000 m OFF ON ON 125 kbps 500 m ON OFF OFF 250 kbps 250 m ON OFF ON 500 kbps 100 m ON ON OFF 800 kbps 50 m ON ON ON 1 Mbps 25 m IN 0 Reserved