AH500 Hardware Manual 2. Address knob s It is used to set the node address of AHRTU-DNET-5A on a DeviceNet network. (Node addresses range from 0 to 63.) Example: If users want to set the communication address of AHRTU-DNET-5A to 26, they can turn the knob corresponding to x10 1 to 2, and turn the knob corresponding to x10 0 to 6. Points for attention: When the power supply is cut off, the node address is set. After the setting of the node address is complete, AHRTU-DNET-5A can be supplied with power. If AHRTU-DNET-5A is running, changing the node address is unavailable. Please use a slotted screwdriver to turn the knobs with care, and do not scrape them. 3.
Function switch The function switch provides the following functions: Setting the working mode (IN 0) Setting the transmission speed of a DeviceNet network (DR 0~DR 1) Note: When the power supply is cut off, the functions are set. After the setting of the functions is complete, AHRTU-DNET-5A can be supplied with power. If AHRTU-DNET-5A is running, changing the functions is unavailable. Please use a slotted screwdriver to adjust the DIP switch with care, and do not scrape them. 4.
DeviceNet connector 3-96 Number Name Description 7 NS LED indicator Indicating the status of the network 8 Label Nameplate 9 Set screw Fixing the module 10 Connector Connecting the module and a backplane 11 Projection Fixing the module Setting Description 0…63 Available nodes on a DeviceNet network 64…99 Unavailable nodes on a DeviceNet network DR 1 DR 0 Transmission speed OFF OFF 125 kbps OFF ON 250 kbps ON OFF 500 kbps ON ON Extended transmission speed IN 1 Reserved ON Clearing the data in the internal storage in AHRTU-DNET-5A IN 0 OFF No action Pin Signal Color Description 1 V+ Red 24 VDC 2 CAN H _ White Signal (positive pole) 3 SHIELD - It is connected to a shielded cable.
4 CAN L _ Blue Signal (negative pole) 5 V- Black 0 VDC