Mitsubishi — 3.10.2 Profiles

Chapter 3 Specifications for Products  AHRTU-PFBS-5A 1. Profile 7 8 9 1. Model name 2. Seven-segment display 3. Address knobs 4. PROFIBUS-DP port 5. RUN LED indicator 6. NET LED indicator 7. Set screw 8. Label 9. Projection 2. Definitions of the pins in the PROFIBUS-DP port 3. Setting a PROFIBUS node address by means of the address knobs The address knobs of AHRTU-PFBS-5A are used for setting the node address of AHRTU-PFBS-5A on a PROFIBUS-DP network. There are two address knobs. They are a knob corresponding to x16 0 , and a knob corresponding to x16 1 . The range for one address knob is 0~F. The range for setting the node address is described below. Example:

If users need to set the node address of AHRTU-PFBS-5A to 26 (decimal value), they have to turn the knob corresponding to x16 1 to “1” and the knob corresponding to x16 0 to “A”. 26 (decimal value)=1A (hexadecimal value)=1x16 1 +Ax16 0 . Points for attention:  If users set the node address of AHRTU-PFBS-5A when AHRTU-PFBS-5A is not supplied with power, they have to power AHRTU-PFBS-5A after the node address of AHRTU-PFBS-5A is set.

 If users change the node address of AHRTU-PFBS-5A when AHRTU-PFBS-5A is powered, the change will not take effect immediately after the node address of AHRTU-PFBS-5A is changed, and it will take effect after the users cut off the power supplied to AHRTU-PFBS-5A and then power AHRTU-PFBS-5A again.  To prevent the address knobs on AHRTU-PFBS-5A from being scratched, please carefully use a slotted screwdriver to rotate the address knobs on AHRTU-PFBS-5A.

3-97 1 2 3 N 4 5 6 x161 x160 ode Address PIN PIN name Description 9 5 6 1 1 -- N/C 2 -- N/C 3 RxD/TxD-P Receiving/Sending data (P (B)) 4 -- N/C 5 DGND Data reference potential (C) 6 VP Supply positive voltage 7 -- N/C 8 RxD/TxD-N Receiving/Sending data (N (A)) 9 -- N/C Address Definition 1 x16 0 x16 H’1~H’7D Valid PROFIBUS address H’0 or H’7E~H’FF Invalid PROFIBUS address