Chapter 5 Wiring 5.8.5.3 Setting a PROFIBUS Node Address by the Knobs The address knobs on AH10PFBM-5A/AH10PFBS-5A are used to set the node address of AH10PFBM-5A/AH10PFBS-5A on a PROFIBUS-DP network. They are knobs which can be turned. One knob corresponds to x16 0 , and the other node corresponds to x16 1 . Setting range: 0~F Example: If the node address of AH10PFBM-5A/AH10PFBS-5A is 26 (decimal value), users have to turn the knob corresponding to x16 1 to position 1, and turn the knob corresponding to x16 0 to position A. 26 (decimal value) = 1A (hexadecimal value)=1Ч16 1 + АЧ16 0 Points for attention:
If users set the node address of AH10PFBM-5A/AH10PFBS-5A when AH10PFBM-5A/AH10PFBS-5A is not supplied with power, they have to power AH10PFBM-5A/AH10PFBS-5A after the node address of AH10PFBM-5A/AH10PFBS-5A is set. If users change the node address of AH10PFBM-5A/AH10PFBS-5A when AH10PFBM-5A/AH10PFBS-5A is powered, the change will not take effect immediately after the node address of AH10PFBM-5A/AH10PFBS-5A is changed, and it will take effect after the users cut off the power supplied to AH10PFBM-5A/AH10PFBS-5A and then power AH10PFBM-5A/AH10PFBS-5A again.
To prevent the address knobs on AH10PFBM-5A/AH10PFBS-5A from being scratched, please carefully use a slotted screwdriver to rotate the address knobs on AH10PFBM-5A/AH10PFBS-5A. 5.8.6 Wiring AH10COPM-5A 5.8.6.1 CANopen Communication Connector A CANopen connector is connected to a CANopen network. Please wire AH10COPM-5A by using the connector attached to AH10COPM-5A. 5.8.6.2 Address Knobs The address knobs on AH10COPM-5A are used to set the node address of AH10COPM-5A on a CANopen network. Setting range:
1~7F (0 and 80~FF can not be used.) 5-57 Address Definition 1 x16 0 x16 H’1~H’7D Valid PROFIBUS node address H’0 or H’7E~H’FF Invalid PROFIBUS node address Pin Signal Description 5 CAN+ 4 SHLD 3 CAN- 2 GND 1 5 - Reserved 4 CAN+ CAN H _ 3 SHLD Shielded cable 2 CAN- CAN L _ 1 GND 0 VDC 1 x16 ADDRESS 0 NODE x16 Setting Description 1~7F Valid CANopen node address 0, 80 ~ FF Invalid CANopen node address