Chapter 5 Wiring *1. If the frequency of input signals received by an input terminal must be 200 kHz, the input terminal must be connected to a 1 kΩ (2 W) resistor in parallel. AH20MC-5A 5-71 Terminal Description c Response c Maximum input haracteristi Curren t Voltage for axis 6. Specifications Item AH20MC-5A Number of actual axes 12 axes Storage The capacity of the built-in storage is 64K steps. Unit Motor unit Compound unit Mechanical unit Users can set the initial register involved in the data exchange in a CPU Connection with a CPU module, and the number of registers involved in the data exchange in the module CPU module.
Four hundred data registers at most can be involved in the data exchange. Delta high-speed motion control system DMCNET (Delta Motion Control Motor control Network) The response time is one millisecond. Single axis: 1M PPS Maximum speed Two-axis interpolation:
1M PPS Operating STOP/RUN (automatic/manual switch) switch Input signal X0.10+, X0.10-, X0.11+, X0.11-, X0.12+, X0.12-, X0.13+, X0.13-, X0.14+, Detector X0.14-, X0.15+, X0.15, X0.0+, X0.0-, X0.1+, X0.1-, X0.2+, X0.2-, X0.3+, X0.3-, X0.8+, X0.8-, X0.9+, X0.9- Servo output Output signal Y0.8, Y0.9, Y0.10, Y0.11 signal Mini USB port External communication port Ethernet port DMCNET port Mini SD card Expansion storage device The maximum capacity is 32 GB. Number of basic instructions 27 Number of applied 130 instructions OX0~OX99 (motion subroutine/positioning program): M02 (The execution of the program stops. (END)) M-code M00~M01, M03~M101, and M103~M65535:
The execution of the program pauses. (WAIT) Users can use them freely. G0 (rapid positioning), G1 (linear interpolation), G2 (circular interpolation, clockwise), G3 (circular interpolation, counterclockwise), G4 (dwell), G17 G-code (XY plane selection), G18 (ZX plane selection), G19 (YZ plane selection), G90 (absolute programming), and G91 (incremental programming)