Mitsubishi — 5.10.3.2 Wiring the Differential Input Terminals

Chapter 5 Wiring 2. An NPN encoder is used. PNP en co der AH04HC-5A hig h-speed cou nte r mod ule OUT Shielde d ca ble X0.8+ X0. 8- Y0 .8 OA OUT Shielde d ca ble OB X0. 9+ X0.9 - Shielde d ca ble d isa ble X0. 0+ X0.0 - St art Ext ernal power su pply Externa l po wer su pply 5~24 VDC 5 V, 12V, 24VDC 5.10.3.2 Wiring the Differential Input Terminals The direct-current signals ranging in voltage from 5 V to 24 V can pass through the high-speed input terminals X0.0+~X0.1+, X0.0-~X0.1-, X0.8+~X0.11+, and X0.8-~X0.11- on AH02HC-5A, and the high-speed input terminals X0.0+~X0.3+, X0.0-~X0.3-, X0.8+~X0.15+, and X0.8-~X0.15- on AH04HC-5A. The frequency of input signals can be up to 200 kHz.

These high-speed input terminals are connected to a differential (two-wire) line driver.  Wiring differential input terminals (The wiring below is used for high speed and high noise.) Encoder output AH04HC-5A high-speed input 5-77 A ph ase B pha se COM B pha se COM +24V 0 .9 +24V 1 A B A+ X0.8 A- X0.8 B + X0 .9 B- X0 .9 + - + - A- X0 .9 B-