Mitsubishi — 8.3 Periodic Maintenance

Chapter 8 Maintenance and Inspection 8.2.2 Daily Inspection * Please refer to Module Manual for more information related to the LED indicators on the extension modules. 8.3 Periodic Maintenance Under the condition that the daily inspection is undertaken, users are suggested that they should carry out the periodic maintenance according to the actual operating environment. After making sure that the ambient environment and the AH500 system conform to the cautions listed in section 8.1, users then can undertake the periodic inspection described below. If any abnormal situation occurs, please follow the remedy and carry out the maintenance. 8-3 No.

Item Inspection Criterion Remedy 1 Appearance Check visually. Dirt must not be present. Remove the dirt. 2 Installation of a backplane Check whether the set screws are loose. The backplane must be installed firmly. Further tighten the screws. Check whether the backplane is installed on the DIN rail properly. Install the backplane on the DIN rail properly. 3 Installation of a module Check whether the module is loose, the projection is inserted into the hole on the backplane, and the screw is tightened. The projection under the module must be inserted into the hole in the backplane, and the screw must be tightened. Install the module firmly.

4 Connection Check whether the removable terminal block is loose. The removable terminal block must not be loose. Install the terminal block firmly. Check whether the connector is loose. The connector must not be loose. Further tighten the screws on the connector. 5 Power supply module POWER LED indicator Check whether the POWER LED indicator is ON. The POWER LED indicator must be ON. Please refer to chapter 9 for more information about the troubleshooting. CPU module RUN LED indicator When the CPU module is running, check whether the RUN LED is ON. The RUN LED indicator must be ON. ERROR LED indicator Check whether the ERROR LED indicator is OFF. The ERROR LED indicator must be OFF.

BUS FAULT LED indicator Check whether the BUS FAULT LED indicator is OFF. The BUS FAULT LED indicator must be OFF. SYSTEM LED indicator Check whether the SYSTEM LED indicator is OFF. The SYSTEM LED indicator must be OFF. LED indicators on an extension module Check whether the LED indicators on the extension module are ON. If the LED indicators are ON, the module operates normally.