Kaiyi — 14.9.4 Configuration of the Master

AH500 Module Manual 23. Click “Address Table” on the left-side window to set the offset addresses of master. For details, please refer to “Mapping relationships between master PLC and slave PLC” in the following section. For the IW or QW-type module, try to adjust the offset address to start at 0 or an even number for the purpose of easy control via the program. User could tick “2 Byte boundaries” to adjust the offset address or not pick “Auto addressing” in the following figure and directly input the offset address value in “Address” column. Click “Process Data” on the left-side window and the details about the slave configuration pop out on the right-side window.

The corresponding relationships between the configured modules of the slave and the modules in the Input list and the Output list in the above figure are shown in the following window. 14-72