Chapter 14 Remote I/O Communication Module AHRTU-PFBS 24. Click “Station Table” on the left-side window and then click the red box on the right-side window to modify the node address of the slave on the software. (Note: Pick the place of “Activate” column as below. Otherwise, the configuration data of the slave will be invalid.) 25. Click “Master Settings” on the left-side window to set the master parameters. (The settings here are default.
For the meaning of each item, please refer to section 10.3.2 in the SYCON.net help.) When there is an IW or QW-type module and its offset address does not start at 0 or an even number, user could tick “2 Byte boundaries” to adjust and make the offset address of each module start at 0 or an even number for the purpose of easy program control. 14-73