Kaiyi — 15.2.4 Address Switches

Chapter 15 CANopen Communication Module AH10COPM 15.2.3 CANopen Communication Connector A CANopen connector is connected to a CANopen network. Please wire AH10COPM-5A by using the connector attached to AH10COPM-5A. CAN+ 4 5 SHLD 3 2 1 GND CAN- 15.2.4 Address Switches The address switches on AH10COPM-5A are used to set the node address of AH10COPM-5A on a CANopen network. Setting range: 1~7F (0 and 80~FF can not be used.) NODE ADDRESS x16 1 x16 0 Example: If the station address of AH10COPM-5A is 16#26, users have to rotate the switch corresponding to x16 1 to position 2, and rotate the switch corresponding to x16 0 to position 6. Points for attention:

 After the station address of AH10COPM-5A is changed, users have to power AH10COPM-5A again, otherwise the change will not take effect.  To prevent the address switches on AH10COPM-5A from being scratched, please carefully use a slotted screwdriver to rotate the address switches on AH10COPM-5A.

15-5 Number Name Description 1 Model name Model name of the module 2 Address switches For setting an address 3 Function switch For setting a function 4 CANopen connector For a CANopen connection 5 RUN LED indicator Operating status of the module 6 ERROR LED indicator Error status of the module 7 Removable terminal block Terminals 8 Set screw Fixing the module 9 Label Nameplate 10 Projection Fixing the module Pin Signal Description 5 - Reserved 4 CAN+ CAN H _ 3 SHLD Shielded cable 2 CAN- CAN L _ 1 GND 0 V DC Setting Description 1~7F Valid CANopen node address 0, 80~FF Invalid CANopen node address