AH500 Module Manual 15.2.5 Function Switch The function switch on AH10COPM-5A is used to set the communication speed at which AH10COPM-5A is connected to a CANopen network. There is a limit on the maximum communication distance to which a communication speed corresponds. After users change the communication speed at which AH10COPM-5A is connected to a CANopen network, they have to power AH10COPM-5A again, otherwise the change will not take effect. To prevent the DIP switch on AH10COPM-5A from being scratched, please carefully use a slotted screwdriver to rotate the DIP switch on AH10COPM-5A. DR 2 DR 1 DR 0 I N 0 15.3 Installation 15.3.1 Installing a Module 1.
Insert the projection under a module into a hole in a backplane. 2. Push the module in the direction indicated by the arrow until it clicks. 15-6 Maximum Communication DR2 DR1 DR0 communication speed distance OFF OFF OFF 10 kbps 5000 m OFF OFF ON 20 kbps 2500 m OFF ON OFF 50 kbps 1000 m OFF ON ON 125 kbps 500 m ON OFF OFF 250 kbps 250 m ON OFF ON 500 kbps 100 m ON ON OFF 800 kbps 50 m ON ON ON 1 Mbps 25 m IN0 Reserved