Kaiyi — 15.4.1 Selecting a Mode

AH500 Module Manual 6. To reduce the reflection of a communication signal on a network, a terminal resistor must connect CAN+ and CAN-. (Specifications for a terminal resistor: 121 Ω; precision: 1%; power: Greater than 1/4 W) 15.4 Configuration 15.4.1 Selecting a Mode Before AH10COPM-5A operates normally, users have to set AH10COPM-5A to Master or Slave by means of HWCONFIG in ISPSoft. After AH10COPM-5A is set, the setting needs to be downloaded to AH10COPM-5A. If the users select Master , they have to use CANopen Builder to configure a network.  Creating a CANopen network An AH500 series CPU module can be connected to eight AH10COPM-5A modules at most.

Before users create a network, they have to know the requirements for creating the network, and plan data exchange, including the slave stations which need to be used, the data which needs to be exchanged, transmission methods, the total quantity of data which needs to be exchanged, and response time. All the information determines whether the network created is reasonable, and whether the network created meets the requirements. It even affects the maintainability at a later stage, and the convenience of upgrading the capacity of the network created. 15-8