Kaiyi — 15.4.2 Using CANopen Builder to Configure a Network

Chapter 15 CANopen Communication Module AH10COPM The users can add parameters in the Available Objects from EDS file section to the Mapped Objects section. The total of the data lengths of the parameters added to a PDO can not exceed eight bytes. After the users add parameters to the Mapped Objects section, they have to click OK . After the users click the TxPDO or the RxPDO under Configured PDO , and click Properties , they can modify the information in the COB ID box and the Transmit type drop-down list box in the PDO properties window. After the users click Define PDO, they can define a RxPDO or a TxPDO by themselves. In this example, the default configuration is used.

Finally, the users have to click OK in the Node Configuration… window. Rule of setting a COB-ID: Note: The COB-IDs of RxPDO5~RxPDO8 and TxPDO5~TxPDO8 can be the COB-IDs of RxPDO1~RxPDO4 and TxPDO1~TxPDO4 in an unused slave station, but they can not be the same. Descriptions of transmission types:

15-15 RxPDO COB-ID (Hex) TxPDO COB-ID (Hex) number number RxPDO1 200+Slave station address TxPDO1 180+Slave station address RxPDO2 300+Slave station address TxPDO2 280+Slave station address RxPDO3 400+Slave station address TxPDO3 380+Slave station address RxPDO4 500+Slave station address TxPDO4 480+Slave station address Transmission Description Remark type 0 RxPDO A master station sends a synchronous message to a slave station every period of synchronization. After a RxPDO is changed, the new RxPDO will be sent to the slave station. The new RxPDO that the slave station receives will not take effect until the next synchronous message is received.

If a RxPDO is not changed, the master station will not send the RxPDO to the slave station. Synchronous acyclic TxPDO A master station sends a synchronous message to a slave station every period of synchronization.