Kaiyi — 16.5.2 EIP Builder

Chapter 16 Remote I/O Module AHRTU-ETHN-5A (1) Before the network time update is set, select “ Enable NTP Client Service ” and then set relevant parameters on the lower part of the following page. Error handling: Set the mechanism for handling errors in AHRTU-ETHN-5A through the software.  When an error occurs in I/O modules, you can select or not select “ Trigger CPU bus fault when RTU I/O fault ”.  When the connection with the CPU fails, you can select “ Stop ” or “ Hold State ” for I/O modules.  When the slave is disconnected, you can select or not select “ Trigger CPU bus fault when RTU is disconnected. ” 16-17