AH500 Module Manual The general browsers at market are supported. See the list of them as below. 16.6 CIP Object Please refer to EtherNet/IP Operation Manual for details. 16.7 Trouble Shooting 16.7.1 Error Type The error codes of AHRTU-ETHN-5A can be classified into RTU error, I/O module error, communication error and other error. For details on error types, see the following table. 16-26 Field Description (All field contents are read only below) Supervisor Status DLR Supervisor status 0: Supervisor as a back up Supervisor Status 1: RTU module works under the mode of Ring Supervisor. 2: End points of ring topology. 3: Non-DLR ring topology. 4:
Ring parameters are unsupported Last Node on Port 1 The IP address of a device that Port 1 connects when the ring topology is disconnected. Last Node on Port 2 The IP address of a device that Port 2 connects when the ring topology is disconnected. Refresh Cycle The default value of the refresh cycle; it is10 with the unit: seconds. “-“ button The value of update cycle is decreased by 1 every time when clicking the button. The min. value of update cycle is 1. “+“ button The value of update cycle is increased by 1 every time when clicking the button. The max. value of update cycle is 60.
Vendor Browser Version Microsoft Internet Explorer V7.0 and above Google Chrome V14 and above Mozilla Firefox V17 and above Error code classification Description 1st Phase 2nd Phase Category Item RTU error Hardware error Hardware error detected after power on Configuration error IP setup error Firmware error Firmware update error I/O module error I/O module error I/O module error I/O module configuration error Actually connected I/O module is different from that configured in the software. Backplane configuration Actually connected backplane is different from that configured in the