AH500 Module Manual Note: The frequency of blinking is 1Hz. “ - ” in the table above means to keep the original state. I/O Indicator 16-30 LED Status Indication How to deal with MS NS conflict addresses in the network. 2. Modify the IP address setup. Network server connection error 1. Check the setup for connecting the server. 2. Check if the system server exists. 3. Check if the wiring for connecting the server is proper. - Green light blinks Firmware update failure 1. Check if the two ends of the network cable are connected correctly. 2. Perform the firmware update once again.
Red light blinks - Status Indication How to deal with Red light blink I/O module error Re-install the I/O module The actually connected I/O module is different from that configured in the software. 1. Re-install the I/O module 2. Repower ON The actually connected backplane is different from that configured in the software. 1. Re-install the backplane 2. Repower ON Red light ON The connection between the main backplane and extension backplane is offline. 1. Check the cable for connection 2. Repower ON