Mitsubishi — 5.10.3 Absolute Two-speed Motion

Chapter 5 Applied Instructions 5-147 Input pin Name Function Data Setting value Time when a value is valid type Position2 Absolute position of the second motion DWORD K-2,147,483,648~ K2,147,483,647 (If the value of the Position1 input pin is greater than 0, the value of the Position2 input pin must be greater than or equal to the value of the Position1 input pin. If the value of the Position1 input pin is less than or equal to 0, the value of the Position2 input pin must be less than or equal to the value of the Position1 input pin.) The value of the Position2 input pin is valid when there is a transition in the Execute input pin’s signal from low to high.

Velocity2 Target speed of the second motion DWORD K1~K2,147,483,647 The value of the Velocity2 input pin is valid when there is a transition in the Execute input pin’s signal from low to high. Output pin Name Function Data type Time when there is Time when there is a transition in an output pin’s signal from high to low a transition in an output pin’s signal from low to high Done The execution of the motion control function block is complete. BOOL  There is a transition in the Done output pin’s signal when motion is complete.  There is a transition in the Done output pin’s signal from high to low when there is a transition in the Execute input pin’s signal from high to low.

 If the Execute input pin is set to False when motion is complete, the Done output pin will be set to False in the next cycle.