AH500 Motion Control Module Manual 5.10.5 Inserting Single-speed Motion 1. Motion control function block The motion control function block T_TrSeg1 is used to insert single-speed motion. The value of the Axis input pin indicates an axis number, and the value of the Velocity input pin indicates the speed of motion. The value of the DogEdge input pin indicates whether motion is triggered by a transition in DOG’s signal from low to high or from high to low. The value of the Distance input pin indicates the distance for which motion moves, and the distance is a relative distance. 2.
Input pins/Output pins 5-154 Input pin Name Function Data Setting value Time when a value is valid type Axis Motion axis number WORD K1~K16 The value of the Axis input pin is valid when there is a transition in the Execute input pin’s signal from low to high. Execute Motion is started when there is a transition in the Execute input pin’s signal from low to high. BOOL True/False - DogEdge Transition in DOG’s signal from low to high or from high to low BOOL mcRising (True)/ mcFalling (False) The value of the DogEdge input pin is valid when there is a transition in the Execute input pin’s signal from low to high.
Distance Distance for which motion moves after a transition in DOG’s signal from low to high or from high to low DWORD K-2,147,483,648~ K2,147,483,647 The value of the Distance input pin is valid when there is a transition in the Execute input pin’s signal from low to high. Velocity Target speed DWORD K1~K2,147,483,647 The value of the Velocity input pin is valid when there is a transition in the Execute input pin’s signal from low to high.