AH500 Motion Control Module Manual Execute 1 t 0 Busy 1 0 1 t t Motion Done 0 3000 Velocity 0 t Position (Rising edge-triggered) t DOG 5. Modules which are supported t The motion control function block T_TrSeg1 supports AH05PM-5A, AH15PM-5A, AH10PM-5A, and AH20MC-5A. 5.10.6 Inserting Two-speed Motion 1. Motion control function block The motion control function block T_TrSeg2 is used to insert two-speed motion. The value of the Axis input pin indicates an axis number, and the value of the Velocity1 input pin indicates the speed of motion. The value of the DogEdge input pin indicates whether motion is triggered by a transition in DOG’s signal from low to high or from high to low.
The value of the Velocity2 input pin indicates the speed of the motion triggered by a transition in DOG’s signal from low to high or from high to low. The value of the Distance input pin indicates the distance for which motion moves, and the distance is a relative distance. 2. Input pins/Output pins 5-158 5000 Input pin Name Function Data Setting value Time when a value is valid type Axis Motion axis number WORD K1~K16 The value of the Axis input pin is valid when there is a transition in the Execute input pin’s signal from low to high.