Mitsubishi — 5.10.6 Inserting Two-speed Motion

Chapter 5 Applied Instructions 5-159 Input pin Name Function Data Setting value Time when a value is valid type Execute Motion is started when there is a transition in the Execute input pin’s signal from low to high. BOOL True/False - DogEdge Transition in DOG’s signal from low to high or from high to low BOOL mcRising (True)/ mcFalling (False) The value of the DogEdge input pin is valid when there is a transition in the Execute input pin’s signal from low to high.

Velocity1 Target speed before a transition in DOG’s signal from low to high or from high to low DWORD K1~K2,147,483,647 The value of the Velocity1 input pin is valid when there is a transition in the Execute input pin’s signal from low to high. Distance Distance for which motion moves after a transition in DOG’s signal from low to high or from high to low DWORD K-2,147,483,648~ K2,147,483,647 The value of the Distance input pin is valid when there is a transition in the Execute input pin’s signal from low to high.

Velocity2 Target speed after a transition in DOG’s signal from low to high or from high to low DWORD K1~K2,147,483,647 The value of the Velocity2 input pin is valid when there is a transition in the Execute input pin’s signal from low to high. Output pin Name Function Data type Time when there is Time when there is a transition in an output pin’s signal from high to low a transition in an output pin’s signal from low to high Done The execution of the motion control function block is complete. BOOL  There is a transition in the Done output pin’s signal when motion is complete.

 There is a transition in the Done output pin’s signal from high to low when there is a transition in the Execute input pin’s signal from high to low.  If the Execute input pin is set to False when motion is complete, the Done output pin will be set to False in the next cycle.