AH500 Motion Control Module Manual 3. Troubleshooting 4. Modules which are supported The motion control function block T_MPG supports AH05PM-5A, AH10PM-5A, AH15PM-5A, and AH20MC-5A. 5.10.9 Returning Home 1. Motion control function block The motion control function block T_HomeReturn is used to start motion of returning home. The value of the Axis input pin indicates an axis number, and the value of the Direction input pin indicates whether the axis specified returns home in the positive direction or in the negative direction. The value of the VRT input pin indicates the speed at which the axis specified returns home.
The value of the DogEdge input pin indicates whether motion is triggered by a transition in DOG’s signal from low to high or from high to low. The value of the VCR input pin indicates the speed to which the speed of the axis specified decreases. The value of the Signal_N input pin is the number of zero pulses. The value of the Distance_P is the number of supplementary pulses needed. After motion of returning home is complete, the value of the HomePosition input pin will be taken as the present position of the axis specified. Please refer to section 7.6 for more information about the normal mode of returning home. 2.
Input pins/Output pins 5-168 Error Troubleshooting The values of input pins in the motion control function block are incorrect. Check whether the values of the input pins are in the ranges allowed. The motion control function block conflicts with other motion control function blocks. Make sure that other uniaxial motion control function blocks are not started or the execution of other uniaxial motion control function blocks is complete before the motion control function block is started.
Input pin Name Function Data Setting value Time when a value is valid type Axis Motion axis number WORD K1~K6 The value of the Axis input pin is valid when there is a transition in the Execute input pin’s signal from low to high.