Mitsubishi — 5.10.8 Manual Pulse Generator Mode

Chapter 5 Applied Instructions 5-167 State of output pin Name Function Data type Time when there is Time when there is a transition in an output pin’s signal from high to low a transition in an output pin’s signal from low to high Busy The motion control function block is being executed. BOOL  The execution of the motion control function block is interrupted by a command.  There is a transition in the Busy output pin’s signal from high to low when there is a transition in the Enable input pin’s signal from high to low.

 If the Enable input pin is set to False when the execution of the motion control function block is interrupted, the Aborted output pin will be set to False in the next cycle. Aborted The execution of the motion control function block is interrupted by a command. BOOL  The execution of the motion control function block is interrupted by a command.  There is a transition in the Aborted output pin’s signal from high to low when there is a transition in the Enable input pin’s signal from high to low. Error An error occurs in the motion control function block. BOOL  Input values are incorrect.  The axis specified is in motion before the motion control function block is executed.

 There is a transition in the Error output pin’s signal from high to low when there is a transition in the Enable input pin’s signal from high to low. Value of output pin Name Function Data Output range Update type InputPulses Number of pulses generated by the manual pulse generator used DWORD K-2,147,483,648~ K2,147,483,647 When the motion control function block is executed, the value of the InputPulses output pin is updated repeatedly. InputFreq Frequency of pulses generated by the manual pulses generator used DWORD K0~K2,147,483,647 When the motion control function block is executed, the value of the InputFreq output pin is updated repeatedly.