Mitsubishi — 5.10.10 Stopping Uniaxial Motion

AH500 Motion Control Module Manual 3. Troubleshooting 5-172 State of output pin Name Function Data type Time when there is Time when there is a transition in an output pin’s signal from high to low a transition in an output pin’s signal from low to high Done The execution of the motion control function block is complete. BOOL  There is a transition in the Done output pin’s signal from low to high when the stopping of the motion of the axis specified is complete.  There is a transition in the Done output pin’s signal from high to low when there is a transition in the Execute input pin’s signal from high to low.

 If the Execute input pin is set to False when the execution of the motion control function block is complete, the Done output pin will be set to False in the next cycle. Busy The motion control function block is being executed. BOOL  There is a transition in the Busy output pin’s signal from low to high when there is a transition in the Execute input pin’s signal from low to high.  There is a transition in the Busy output pin’s signal from high to low when there is a transition in the Done output pin’s signal from low to high.  There is a transition in the Busy output pin’s signal from high to low when there is a transition in the Error output pin’s signal from low to high.

 There is a transition in the Busy output pin’s signal from high to low when there is a transition in the Aborted output pin’s signal from low to high. Error An error occurs in the motion control function block. BOOL  Input values are incorrect.  The motion of the axis specified is not uniaxial motion, gear motion, or cam motion.  There is a transition in the Error output pin’s signal from high to low when there is a transition in the Execute input pin’s signal from high to low. Error Troubleshooting The values of input pins in the motion control function block are incorrect. Check whether the values of the input pins are in the ranges allowed.

The motion control function block conflicts with other motion control function blocks. Make sure that other uniaxial motion control function blocks are not started or the execution of other uniaxial motion control function blocks is complete before the motion control function block is started.