Chapter 5 Applied Instructions 3. Troubleshooting 4. Modules which are supported The motion control function block T_CamRea supports AH05PM-5A, AH10PM-5A, AH15PM-5A, and AH20MC-5A. 5-195 State of output pin Name Function Data type Time when there is Time when there is a transition in an output pin’s signal from high to low a transition in an output pin’s signal from low to high Valid An output value is valid. BOOL There is a transition in the Valid output pin’s signal from low to high when there is a transition in the Enable input pin’s signal from low to high.
There is a transition in the Valid output pin’s signal from high to low when there is a transition in the Enable input pin’s signal from high to low. There is a transition in the Valid output pin’s signal from high to low when there is a transition in the Error output pin’s signal from low to high. Busy The motion control function block is being executed. BOOL There is a transition in the Busy output pin’s signal from low to high when there is a transition in the Enable input pin’s signal from low to high. There is a transition in the Busy output pin’s signal from high to low when there is a transition in the Enable input pin’s signal from high to low.
There is a transition in the Busy output pin’s signal from high to low when there is a transition in the Error output pin’s signal from low to high. Error An error occurs in the motion control function block. BOOL Input values are incorrect. There is a transition in the Error output pin’s signal from high to low when there is a transition in the Enable input pin’s signal from high to low. Value of output pin Name Function Data Output range Time when a value is valid type MasterPosition Position of the master axis specified DWORD K-2,147,483,647~ K2,147,483,647 When the motion control function block is executed, the value of the MasterPosition output pin is updated repeatedly.
SlavePosition Position of the slave axis specified DWORD K-2,147,483,647~ K2,147,483,647 When the motion control function block is executed, the value of the SlavePosition output pin is updated repeatedly. Error Troubleshooting The values of input pins in the motion control function block are incorrect. Check whether the values of the input pins are in the ranges allowed.