Mitsubishi — 5.11.1 Setting the Parameters of G-code Motion

Chapter 5 Applied Instructions 5.11 Multiaxial Motion Control Function Blocks 5.11.1 Setting the Parameters of G-code Motion 1. Motion control function block The motion control function block T_GcodeSetting is used to set the parameters of G-code motion. The value of the ContIP input pin indicates the minimum speed to which the speed of continuous interpolation decreases. If the speed of G-code motion is less than the speed indicated by the value of the ContIP input pin, the G-code motion will move at the speed indicated by the value of the ContIP input pin. The value of the VelPercentage input pin indicates the percentage for the values of the speed parameters of G-codes. 2.

Input pins/Output pins 5-205 Input pin Name Function Data Setting value Time when a value is valid type Execute The parameters of G-code motion are set when there is a transition in the Execute input pin’s signal from low to high. BOOL True/False - ContIP Minimum speed to which the speed of continuous interpolation decreases DWORD K0~K500000 The value of the ContIP input pin is valid when there is a transition in the Execute input pin’s signal from low to high. VelPercentage Percentage for the values of the speed parameters of G-codes WORD K0~K65,535 The value of the VelPercentage input pin is valid when there is a transition in the Execute input pin’s signal from low to high.