Mitsubishi — 5.11.7 Stopping Multiaxial Linear Interpolation

AH500 Motion Control Module Manual 3. Troubleshooting 4. Modules which are supported The motion control function block T_GroupStop supports AH05PM-5A, AH10PM-5A, AH15PM-5A, and AH20MC-5A. 5-220 Input pin Name Function Data Setting value Time when a value is valid type AxesGroup Axes which execute interpolation WORD[6] [ , , , , , ] ______ 0: Not setting axes n: Adding the nth axis (n is in the range of 1 to 16.) (The first cell must be set.) The value of the AxesGroup input pin is valid when there is a transition in the Execute input pin’s signal from low to high.

State of output pin Name Function Data type Time when there is Time when there is a transition in an output pin’s signal from high to low a transition in an output pin’s signal from low to high Done The execution of the function block is complete. BOOL  There is a transition in the Done output pin’s signal from low to high when the stopping of multiaxial linear interpolation is complete.  There is a transition in the Done output pin’s signal from high to low when there is a transition in the Execute input pin’s signal from high to low.  If the Execute input pin is set to False when motion is complete, the Done output pin will be set to False in the next cycle.

Busy The motion control function block is being executed. BOOL  There is a transition in the Busy output pin’s signal from low to high when there is a transition in the Execute input pin’s signal from low to high.  There is a transition in the Busy output pin’s signal from high to low when there is a transition in the Error output pin’s signal from low to high.  There is a transition in the Busy output pin’s signal from high to low when there is a transition in the Done output pin’s signal from low to high. Error An error occurs in the motion control function block. BOOL  Input values are incorrect.

 There is a transition in the Error output pin’s signal from high to low when there is a transition in the Execute input pin’s signal from high to low. Error Troubleshooting The values of input pins in the motion control function block are incorrect. Check whether the values of the input pins are in the ranges allowed.