Mitsubishi — 5.12.1 Starting/Stopping a Servo Drive

Chapter 5 Applied Instructions 5.12 Network Function Blocks 5.12.1 Starting/Stopping a Servo Drive 1. Motion control function block The motion control function block T_DMCPowerUp is used to start or stop the servo drive specified on a DMCNET. The value of the Axis input pin indicates an axis number. 2. Input pins/Output pins 5-221 Input pin Name Function Data Setting value Time when a value is valid type Axis Motion axis number WORD 1~12 The value of the Axis input pin is valid when there is a transition in the Execute input pin’s signal from low to high. Enable The servo drive specified on a DMCNET is started when there is a transition in the Enable input pin’s signal from low to high.

The servo drive specified on a DMCNET is stopped when there is a transition in the Enable input pin’s signal from high to low. BOOL True/False - State of output pin Name Function Data type Time when there is Time when there is a transition in an output pin’s signal from high to low a transition in an output pin’s signal from low to high Valid An output value is valid. BOOL  There is a transition in the Valid output pin’s signal from low to high when there is a transition in the Enable input pin’s signal from low to high.  There is a transition in the Valid output pin’s signal from high to low when there is a transition in the Error output pin’s signal from low to high.