Mitsubishi — 5.12.2 Resetting a Servo Drive

AH500 Motion Control Module Manual 3. Troubleshooting 4. Modules which are supported The motion control function block T_DMCPowerUp supports AH20MC-5A. 5.12.2 Resetting a Servo Drive 1. Motion control function block The motion control function block T_DMCRest is used when a network is abnormal. After a network is reset by the motion control function block T_DMCRest, users will have to use the motion control function block T_DMCControllnit to connect the motion control module and the servo drive which are used to the network. 2.

Input pins/Output pins 5-222 State of output pin Name Function Data type Time when there is Time when there is a transition in an output pin’s signal from high to low a transition in an output pin’s signal from low to high Busy The motion control function block is being executed. BOOL  There is a transition in the Busy output pin’s signal from low to high when there is a transition in the Enable input pin’s signal from low to high.  There is a transition in the Busy output pin’s signal from high to low when there is a transition in the Enable input pin’s signal from high to low.

 There is a transition in the Busy output pin’s signal from high to low when there is a transition in the Error output pin’s signal from low to high. Error An error occurs in the motion control function block. BOOL  Input values are incorrect.  There is a transition in the Error output pin’s signal from high to low when there is a transition in the Enable input pin’s signal from high to low. Error Troubleshooting The values of input pins in the motion control function block are incorrect. Check whether the values of the input pins are in the ranges allowed.

Input pin Name Function Data Setting value Time when a value is valid type Axis Motion axis number WORD 1~12 The value of the Axis input pin is valid when there is a transition in the Execute input pin’s signal from low to high.