Mitsubishi — 5.12.5 Instructing a Servo Drive to Return Home

Chapter 5 Applied Instructions Steps: (a) Write the value of a parameter into the servo drive specified by means of the motion control function block named FB1. (b) After the execution of the motion control function block named FB1 is complete, the motion control function block named FB2 will be executed automatically. (c) After the execution of the motion control function block name FB2 is complete, Done2 will be set to True. The value of the Value of output pin in the motion control function block named FB2 is the value read from the servo drive specified.

(d) The value of the Value of output pin in the motion control function block named FB2 should be the same as the value of the Value input pin in the motion control function block named FB1. Timing diagram: 5. Modules which are supported The motion control function block T_DMCServoRead supports AH20MC-5A. 5.12.5 Instructing a Servo Drive to Return Home 1. Motion control function block The motion control function block T_DMCServoHoming is used to instruct the servo drive specified on a DMCNET to return home. The value of the Axis input pin indicates an axis number, and the value of the Mode input pin indicates a mode of returning home.

After the servo drive specified returns home, the value of the Offset input pin will indicate an offset. 5-229