Mitsubishi — 5.12.5 Instructing a Servo Drive to Return Home

AH500 Motion Control Module Manual 2. Input pins/Output pins 5-230 Input pin Name Function Data Setting value Time when a value is valid type Axis Motion axis number WORD 1~12 The value of the Axis input pin is valid when there is a transition in the Execute input pin’s signal from low to high. Execute Motion is started when there is a transition in the Execute input pin’s signal from low to high. BOOL True/False - Mode Mode of returning home WORD 1~35 The value of the Mode input pin is valid when there is a transition in the Execute input pin’s signal from low to high.

Offset Offset WORD K-32,767~K32,767 The value of the Offset input pin is valid when there is a transition in the Execute input pin’s signal from low to high. VRT Speed at which the servo drive specified returns home Unit: RPM DWORD K1~K2000 The value of the VRT input pin is valid when there is a transition in the Execute input pin’s signal from low to high. VCR Speed to which the speed of the servo drive specified decreases Unit: RPM DWORD K1~K500 The value of the VCR input pin is valid when there is a transition in the Execute input pin’s signal form low to high.

State of output pin Name Function Data type Time when there is Time when there is a transition in an output pin’s signal from high to low a transition in an output pin’s signal from low to high Done The execution of the motion control function block is complete. BOOL  There is a transition in the Done output pin’s signal from low to high when motion of returning home is complete.  There is a transition in the Done output pin’s signal from high to low when there is a transition in the Execute input pin’s signal from high to low.  If the Execute input pin is set to False when motion is complete, the Done output pin will be set to False in the next cycle.