Chapter 5 Applied Instructions *1: Value of the Channel input pin 3. Troubleshooting 4. Modules which are supported The motion control function block T_HTmr supports AH05PM-5A, AH10PM-5A, AH15PM-5A, and AH20MC-5A. 5-247 State of output pin Name Function Data type Time when there is Time when there is a transition in an output pin’s signal from high to low a transition in an output pin’s signal from low to high Busy The motion control function block is being executed. BOOL There is a transition in the Busy output pin’s signal from low to high when there is a transition in the Enable input pin’s signal from low to high.
There is a transition in the Busy output pin’s signal from high to low when there is a transition in the Error output pin’s signal from low to high. There is a transition in the Busy output pin’s signal from high to low when there is a transition in the Enable input pin’s signal from high to low. Error An error occurs in the motion control function block. BOOL Input values are incorrect. The source specified has been occupied. There is a transition in the Error output pin’s signal from high to low when there is a transition in the Enable input pin’s signal from high to low.
Value of output pin Name Function Data Output range Time when a value is valid type TimerValue Value in the timer specified DWORD K0~K2,147,483,647 When the motion control function block is executed, the value of the TimerValue of output pin is updated repeatedly. If there is no trigger, the value in the timer specified will remain unchanged. Value Definition Terminal 0 C200 X0.0 1 C204 X0.1 2 C208 X0.2 3 C212 X0.3 Error Troubleshooting The values of input pins in the motion control function block are incorrect. Check whether the values of the input pins are in the ranges allowed.