AH500 Motion Control Module Manual *1: Wiring hardware *2: Setting the resolution of an encoder Specifications for an SSI encoder: Resolution of an encoder: Resolution per rotation+Number of rotations+1=13+12+1=26 3. Troubleshooting 5-260 State of output pin Name Function Data type Time when there is Time when there is a transition in an output pin’s signal from high to low a transition in an output pin’s signal from low to high Aborted The execution of the motion control function block is interrupted by a command. BOOL The execution of the motion control function block is interrupted by a command.
There is a transition in the Aborted output pin’s signal from high to low when there is a transition in the Execute input pin’s signal from high to low. If the Execute input pin is set to False when the execution of the motion control function block is interrupted, the Aborted output pin will be set to False in the next cycle. Error An error occurs in the motion control function block. BOOL Input values are incorrect. The axis specified is in motion before the motion control function block is executed. There is a transition in the Error output pin’s signal from high to low when there is a transition in the Execute input pin’s signal from high to low.
Value of output pin Name Function Data Output range Update type Position Present position of an encoder DWORD K0~K2,147,483,647 When there is a transition in the Done output pin’s signal from low to high, the value of the Position output pin is updated. T+ T- D+ D- Group number 1 Y0.0+ Y0.0- X0.0+ X0.0- 2 Y0.2+ Y0.2- X0.1+ X0.1- 3 Y0.4+ Y0.4- X0.2+ X0.2- 4 Y0.6+ Y0.6- X0.3+ X0.3- Item Specification Resolution per rotation 8192 (13 bits) Number of rotations 4096 (12 bits) Error Troubleshooting The values of input pins in the motion control function block are incorrect. Check whether the values of the input pins are in the ranges allowed.