Mitsubishi — 7.1 Functions of Uniaxial Motion

AH500 Motion Control Module Manual *1. HW: High word; LW: Low word *2. Unit: µm/rev, mdeg/rev, and 10 -4 inches/rev *3. The unit used varies with the setting of bit 0 and bit 1 in SR1000+100*N. 7-4 SR number Factory (1+N)th axis*4 Function Setting range setting HW*1 LW*1 - SR1041+100*N Axis error code Please refer to the error code tables in appendix A.

16#0 - SR1042+100*N Electronic gear ratio of the axis specified (Numerator) 1~32,767 K1 - SR1043+100*N Electronic gear ratio of the axis specified (Denominator) 1~32,767 K1 SR1045+100*N SR1044+100*N Frequency of pulses generated by the manual pulse generator for the axis specified Frequency of pulses generated by the manual pulse generator for the axis specified K0 SR1047+100*N SR1046+100*N Number of pulses generated by the manual pulse generator for the axis specified Number of pulses generated by the manual pulse generator for the axis specified K0 - SR1048+100*N Response speed of the manual pulse generator for the axis specified Response speed of the manual pulse generator for the axis specified K5 - SR1049+100*N Mode of stopping Ox0~Ox99 Users can set SR1049+100*N according to their needs.

K0 SR1051+100*N SR1050+100*N Electrical zero of the axis specified Users can set (SR1051+100*N, SR1050+100*N) according to their needs. K0 - SR1052+100*N Setting an Ox motion subroutine number Users can set SR1052+100*N according to their needs. K0 - SR1053+100*N Step address in the Ox motion subroutine at which an error occurs Users can set SR1053+100*N according to their needs. K0 SR1069+100*N SR1068+100*N Present position of the encoder specified on a DMCNET*5 The value displayed in (SR1069+100*N, SR1068+100*N) is a value set in a Delta ASDA-A2 series servo drive. K0