Chapter 8 Electronic Cam Length of a cutting=Circumference of the blade used: The cutting roller used rotates at a uniform speed. Ratio of the speed of the slave axis to the speed of the master axis 1 Position of the master axis One time the circumference of the blade used circumference of the blade used: After the cutting roller used completes cutting in the synchronization zone designed, it will decelerate, and then accelerate until its speed is the same the speed of the feeding roller used. Ratio of the speed of the slave axis to the speed of the master axis Synchronization zone Position of the master axis Length of a cutting>Two times the circumference of the blade used:
The length of a cutting is greater than two times the circumference of the blade. (It is a common situation.) After the blade used completes cutting in a cycle, it will decelerate until it stops. After a material of a certain length is fed, the blade used will start cutting again. Ratio of the speed of the slave axis to the speed of the master axis Synchronization zone Position of the master axis 8.4.1 Creating Rotary Cut Data Users can create a rotary cut curve by means of creating electronic cam data in a way introduced in section 8.3. Besides, an AH500 series motion control module provides the motion control function block T_CamCurve.
T_CamCurve can be used to automatically create cam data. 8-21