Mitsubishi — 8.4.4 Example

Chapter 8 Electronic Cam 3. After M0 is set to True, a synchronization ratio will be calculated. 4. After M10 is set to True, a cam curve will be created. The synchronization zone gotten is in the range of 9,927 pulses to 11,723 pulses. 5. Update the cam data in the AH500 series motion control module, and then check whether the cam chart created is correct.  The distance for which the master axis specified moves is the same as the length set, that is, the distance for which the master axis specified moves is 15,915 pulses.

 The synchronization ratio of the speed of the slave axis specified to the speed of the master axis specified is the same as the value of the SyncRatio output pin in the motion control function block T_CamSyncRatio.  The distance for which the slave axis specified is synchronized with the master axis specified is 3,000 pulses.  The synchronization zone gotten is in the range of 9,927 pulses to 11,723 pulses. The distance for which the master axis specified is synchronized with the slave axis specified is 1,796 pulses.

 Distance for which the slave axis specified is synchronized with the master axis specified = Distance for which the master axis specified is synchronized with the slave axis specifiedЧSynchronization ratio, that is, 1,796 1.6702=3000 Ч .  After M70 is set to True, electronic cam motion will be started.  After M72 is set to True, the slave axis specified will not mesh with the master axis specified. 8-31