Mitsubishi — 8.4.4 Example

AH500 Motion Control Module Manual 【 Control program 】 1. Using the motion control function block T_CamCurve to automatically create an electronic cam curve  Users have to set the length of a cutting. The length of a cutting is 500 mm. 500 mm      →  Conversion 915 , 15 100 000 ,1 500 = Ч π  The circumference of a slave axis specified is the number of pulses it takes for the slave axis to rotate once. In this example, the circumference of the slave axis specified is 10,000 pulses.  The distance for which a slave axis is synchronized with a master axis is thirty percent of the circumference of the slave axis.

000 3 30 000 10 , % , = Ч  Calculating a synchronization ratio  The circumference of the master axis specified is 314 mm.  The number of pulses it takes for the master axis specified to rotate once is 10,000.  The circumference of the slave axis specified is 188 mm.  The number of pulses it takes for the slave axis specified to rotate once is 10,000.  Maximum ratio of the speed of the slave axis specified to the speed of the master axis specified: Ten times the synchronization ratio of the speed of the slave axis specified to the speed of the master axis specified.  Acceleration curve: Uniform curve  Rotary cut curve: rightCAM  The Concatenate input pin is set to False.

After the input pins in the motion control function block T_CamCurve are set in accordance with the setting described above, a cam curve can be created. 2. Main program in PMSoft 【 Steps 】 1. Open a CAM Chart window in PMSoft, and then type 300 in the Resolution box. 2. Download the program created to an AH500 series motion control module, and then execute the program. 8-30