Mitsubishi — 9.4 Descriptions of G-code Instructions

Chapter 9 Multiaxial Interpolation 9.4 Descriptions of G-code Instructions G-code 0000 Description:  P 1 : Target position of an x-axis; P 2 : Target position of a y-axis; P 3 : Target position of a z-axis; P 4 : Target position of an A-axis; P 5 : Target position of a B-axis; P 6 : Target position of a C-axis  If the value of a parameter is not a floating-point value, it must be in the range of -2,147,483,648 to 2,147,483,647. If the value of a parameter is a floating-point value, it must be in the range of-2,147,483.648 to 2,147,483.647.  Users do not need to set the speeds at which the axes used moves. The speed at which an axis moves is its maximum speed.

 Users only need to specify one target position or more than one target position.  Operation Velocity Maximum speed Start-up speed Time Time it takes for the axis specified to decelerate Time it takes for the axis specified to accelerate  Users can set the time it takes for an axis specified to accelerate/decelerate and the start-up speed of the axis by means of special data registers.  The time it takes for an axis specified to accelerate/decelerate is proportional to the maximum speed of the axis.

9-5 Instruction code Operand Function G00 X P Y P Z P A P 1 2 3 4 B P C P 5 6 Rapid positioning Device K 16# F D DD W WW P 1       P 2       P 3       P 4       P 5       P 6       Number of pulses output