Chapter 9 Multiaxial Interpolation 0001 Description: P 1 : Target position of an x-axis; P 2 : Target position of a y-axis; P 3 : Target position of a z-axis; P 4 : Target position of an A-axis; P 5 : Target position of a B-axis; P 6 : Target position of a C axis; V : Speed of linear interpolation If the value of P 1 / P 2 / P 3 is not a floating-point value, it must be in the range of -2,147,483,648 to 2,147,483,647, and the value of V must be in the range of 0 to 500,000. If the value of P 1 / P 2 / P 3 is a floating-point value, it must be in the range of-2,147,483.648 to 2,147,483.647, and the value of V must be in the range of 0 to 500.0.
If users specify a speed for G01, the speed of interpolation will be the speed specified. If no speed is specified for the instruction, the speed of interpolation will be the speed specified for G01/G02/G03 which precedes G01. V : Maximum speed of interpolation Users only need to specify one target position or more than one target position. Operation Velocity Maximum speed Start-up speed Time Time it takes for the axis specified to decelerate Time it takes for the axis specified to accelerate Users can set the time it takes for an axis specified to accelerate/decelerate and the start-up speed of the axis by means of special data registers.
The time it takes for an axis specified to accelerate/decelerate is proportional to the maximum speed of the axis. 9-7 Instruction code Operand Function G01 X P Y P Z P A P 1 2 3 4 B P C P F V 5 6 Linear interpolation (The distance remaining can be considered.) Device K 16# F D DD W WW P 1 P 2 P 3 P 4 P 5 P 6 V Number of pulses output