Chapter 9 Multiaxial Interpolation If G19 is used, and the postion of an x-axis does not change, helical interpolation will be equivalent to circular interpolation. Z-axis Z-axis Start point Center point Center point Center point End point (x, y, z) (J, K) End point ( y, z) Center point End point (x, y, z) (J, K) (J, K) ( y,z) (J, K) Start point End point Start point X=0 X=0 X-axis Y-axis X=0 Y-axis X-axis Start point X=0 G03 (Counterclockwise interpolation) G02 (Clockwise interpolation) Principles of writing an instruction: (1) Users have to specify a target position, and an arc center. They do not have to specify the speed of interpolation.
(2) If there is no vector from the present position of an axis to its target position, users do not need to specify the target position of the axis. (3) If there is no vector from the present position of an axis to an arc center, users do not need to specify a vector. The circular/helical instrctions listed below are available. 9-11 NO.
G-code Combination of operands G17 G18 G19 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 X X X X X X Y Y Y Y G02/G03 Y Y X X X X X X X X P I P 1 3 P I P F V 1 3 P J P 1 4 P J P F V 1 4 P I P J P 1 3 4 P I P J P F V 1 3 4 P I P 2 3 P I P F V 2 3 P J P 2 4 P J P F V 2 4 P I P J P 2 3 4 P I P J P F V 2 3 4 P Y P I P 1 2 3 P Y P I P F V 1 2 3 P Y P J P 1 2 4 P Y P J P F V 1 2 4 P Y P I P J P 1 2 3 4 P Y P I P J P F V 1 2 3 4 P Z P I P 1 3 3 P Z P I P F V 1 3 3