AH500 Motion Control Module Manual With mode: An M-code is in back of a motion instruction. The execution of G01 is complete. G01 M100 SM 1050 When the execution of G01 is triggered, the M-code M100 is started automatically, and SM1050 is automatically turned ON. If users want to stop M100, they have to turn SM1050 OFF. If they want o start the M-code again, they have to set parameters after the execution of G01 is complete, and create a program that starts the M-code again. 9.6 Description of TO An AH500 series motion control module can start and stop linear interpolation by means of the instruction TO. The use of TO to set linear interpolation is described below. CR#2:
Starting interpolation X0 Quantity of data Initial device Data CR number Module number The device ( S , S +1 ) is described below. Evey axis is controlled by two bits in ( S , S +1 ). 9-24 LIN XKK500 Y300.0 F5000 M100 0 TO K253 K2 S N Device Setting S, S +1 Axes specified S , S +2 +3 Speed of interpolation S , S +4 +5 Poistion of the first axis S , S +6 +7 Position of the second axis S , S +8 +9 Poistion of the third axis : :
S , S +29 +28 Position of the fifteenth axis S , S +31 +30 Position of the sixteenth axis Bit 31 30 29 28 27 26 25 24 23 22 21 20 19 18 17 16 Axis number 16th axis 15th axis 14th axis 13th axis 12th axis 11th axis 10th axis 9th axis Bit 15 14 13 12 11 10 9 8 7 6 5 4 3 2 1 0 Axis number 8th axis 7th axis 6th axis 5th axis 4th axis 3rd axis 2nd axis 1st axis Value Definition 0 Not participating in interpolation