Chapter 9 Multiaxial Interpolation CR#3: Stopping interpolation X0 Data CR number Module number Quantity of data Initial device The device ( S , S +1 ) is described below. Evey axis is controlled by two bits in ( S , S +1 ). Users can set the parameters of the axes participating in linear interpolation by means of SR1000+100*N.
9-25 Value Definition 1 Participating in interpolation 2 Not used 3 Not used TO K253 K3 S N TO K253 K3 S N Device Setting S, S +1 Axes specified Bit 31 30 29 28 27 26 25 24 23 22 21 20 19 18 17 16 Axis number 16th axis 15th axis 14th axis 13th axis 12th axis 11th axis 10th axis 9th axis Bit 15 14 13 12 11 10 9 8 7 6 5 4 3 2 1 0 Axis number 8th axis 7th axis 6th axis 5th axis 4th axis 3rd axis 2nd axis 1st axis Value Definition 0 Not participating in interpolation 1 Stopping linear interpolation 2 Not used 3 Not used Special data register SR1000+100*N b15 b14 b13 b12 b11 b10 b9 b8 b7 b6 b5 b4 b3 b2 b1 b0 - Curve (Note 3) Mode of triggering the calculation of the target position Relative/Absolute coordinates Direction in which the motor used rotates Mode of triggering the return to home Mode of returning home Direction in which the axis specified returns home - - Output type (Positive logic) (Note 2) - Unit (Note 1)