AH500 Motion Control Module Manual 12.1 Functions The Ethernet port on an AH500 series motion control module can exchange data with a network device through a general networking cable. The Ethernet port on an AH500 series motion control has the following functions. It can be connected to PMSoft. A program can be uploaded/downloaded and monitored. It can function as a standard Modbus TCP slave. 12.2 Specifications Ethernet connector Communication 12.3 Introduction of Parameters SR808 and SR809: Ethernet IP address [Description] If users want to set the IP address of an AH500 series motion control module, two registers will used.
The initial IP address of an AH500 series motion control module is 192.168.0.100. 12.4 Communication Function of PMSoft Setting an Ethernet IP The default Ethernet IP address of an AH500 series motion control module is 192.168.0.100. Users can change the Ethernet IP address of an AH500 series motion control module by means of SR808 and SR809. After an AH500 series motion control module is disconnected, its IP address will not be retained. Its IP address becomes 192.168.0.100 after it is supplied with power again. Alternatively, the users can set an IP address by means of a motion control function block.
The motion control function block which can be used to set an IP address is shown below. The IPv4_1 input pin, the IPv4_2 input pin, the IPv4_3 input pin, and the IPv4_4 input pin are used to set an IP address. After the setting of the input pins is complete, the Done output pin 12-2 Item Specifications Transmission type Ethernet Electrical isolation 500 V DC Connector Removable connector (5.08 mm) Transmission cable Four communication cables Item Specifications Data type TCP/IP Serial transmission speed 10 M/100 M (bit∕second) Maximum transmission distance 100 meters SR809 SR808 High byte Low byte High byte Low byte 192 168 0 100