Mitsubishi — 12.4 Communication Function of PMSoft

Chapter 12 Setting an Ethernet Network will be ON.  Connecting the Ethernet port on an AH500 series motion control module to PMSoft If an AH500 series motion control module equipped with an Ethernet port is connected to PMSoft, users can upload/download and monitor a program through Ethernet.  Wiring hardware Users can connect the Ethernet port on an AH500 series motion control module to an Ethernet port on a personal computer by means of a general networking cable. After an AH500 series motion control module is connected to a personal computer, the Ethernet connection LED indicator on the AH500 series motion control module will be ON.

If the Ethernet connection LED indicator is not ON, users have to check whether the setting of the module or the personal computer is incorrect.  Setting COMMGR  Users can type a driver name in the Driver Name box.  Select Ethernet in the Type drop-down list box in the Connection Setup section.  Select a network interface card in the Description drop-down list box. The IP address assigned to the network interface card selected is displayed in the lower left corner of the Ethernet Card section.  Owing to the characteristics of Ethernet, a computer can communicate with all devices on a network.

Users can create the IP addresses of the devices connected to this driver in the IP Address Setting section.  After users click Add to add a new IP address to the list of IP addresses in the IP Address Setting section, they can type related information in the IP Address cell, the Port Number cell, and the Comment cell.  Users can type the IP address of a device connected in this cell.  Users can type the communication port number specified.  Users can type a comment in this cell.    12-3