Mitsubishi — 14.6 DMCNET Motion Control

Chapter 14 DMCNET 16#012C. 4. The users have to write 3 into bit 11~bit 8 in SR1072 (SR1172, SR1272…). 5. The users can check whether the reading of a value is correct by means of bit 11~bit 8 in SR1073 (SR1173, SR1273…). If an error occurs, an error code will be stored in (SR1077, SR1076) ((SR1177, SR1176), (SR1277, SR1276)…). If the reading of a value is successful, the value of bit 11~bit8 in SR1073 (SR1173, SR1273…) will be 0. 6. After a value is read successfully, the users can know the value by means of (SR1077, SR1076) ((SR1177, SR1176), (SR1277, SR1276)…). 7.

The users can write a value into another servo drive or read a value from another servo drive only after the setting of the servo used is complete, or an error occurs in the servo used.  Using a motion control function block Users can read a value from a servo drive by means of the motion control function block T_DMCServoRead. Please refer to Chapter 5 for more information about the input pins and the output pins in the motion control function block T_DMCServoRead. 14.6 DMCNET Motion Control  Retuning home  Using special data registers Before users instruct the servo drive used to return home by means of a DMCNET, they have to make sure of the following points. 1.

The value of bit 0~bit 3 in SR1073 (SR1173, SR1273…) is 2, that is, the servo drive used is ON. 2. When the servo drive used touches the left/right limit switch set and DOG’s signal, it determines its operation. The users have to connect a left/right limit switch and DOG to the connector on the servo drive used. The users have to refer to section 3.4.2 in ASDA-A2 Series User Manual for more information. After the users make sure of the points above, they can set a mode of returning home. 1. The users have to write 4 into bit 11~bit 8 in SR1072 (SR1172, SR1272…). 2. The users have to set a way in which the servo drive used returns home by means of SR1078 (SR1178, SR1278…).

After SR1078 (SR1178, SR1278…) is set, the servo drive used will begin to return home. 3. When the servo drive used returns home, the value of bit11~bit 8 in SR1073 (SR1173, SR1273…) is 1. After the servo drive used returns home, the value of bit 11~bit 8 in SR1073 (SR1173, SR1273…) will become 0. 4. After the servo drive used returns home, its present position will be the same as the present position of its corresponding axis. 14-11