Mitsubishi — 14.6 DMCNET Motion Control

AH500 Motion Control Module Manual  Using a motion control function block Users can instruct a servo drive to return home by means of the motion control function block T_DMCServoHoming. Please refer to Chapter 5 for more information about the input pins and the output pins in the motion control function block T_DMCServoHoming. There are several modes of returning home. These modes are described below.  The value in SR1078 (SR1178, SR1278…) is 1. The motor used rotates clockwise. After it comes into contact with the negative limit switch specified, it will rotate counterclockwise until a transition in a Z-phase signal from low to high occurs.  The value in SR1078 (SR1178, SR1278…) is 2.

The motor used rotates counterclockwise. After it comes into contact with the positive limit switch specified, it will rotate clockwise until a transition in a Z-phase signal from low to high occurs.  The value in SR1078 (SR1178, SR1278…) is 3 or 4. 1. The value in SR1078 (SR1178, SR1278…) is 3. The motor used rotates counterclockwise. After a transition in DOG’s signal from low to high occurs, the motor will rotate clockwise until a transition in a Z-phase signal from low to high occurs. 2. The value in SR1078 (SR1178, SR1278…) is 4. The motor used rotates counterclockwise. After a transition in DOG’s signal from low to 14-12