Mitsubishi — 14.6 DMCNET Motion Control

AH500 Motion Control Module Manual  DMCNET motion In a DMCNET motion mode, AH20MC-5A can update the commands sent to the twelve axes simultaneously. It only takes 1 millisecond to update the commands sent to the twelve axes in AH20MC-5A. After a special data register is set to DMCNET motion mode, a servo drive will be set to DMCNET motion mode. Some of the twelve axes in AH20MC-5A can be instructed to return home, and the others can operate in DMCNET motion modes. If servo drives operate in DMCENT motion modes, they will support uniaxial motion and multiaxial motion. The steps of setting a DMCNET motion mode are as follows. 1.

Users have to make sure that the value of bit 0~bit 3 in SR1073 (SR1173, SR1273…) is 2. 2. The users have to write 5 into bit 11~bit 8 in SR1072 (SR1172, SR1272…). 3. The users have to make sure that the value of bit 11~bit 8 in SR1073 (SR1173, SR1273…) is 1, that is, they have to make sure that the servo drive specified operates in a DMCNET motion mode. 4. The users can control the axis specified by means of uniaxial motion. They can set special data registers for uniaxial motion. 5. If the users want to control axes by means of multiaxial interpolation, they can write G-codes. 6.

If users want to instruct the axis specified to return home, they have to write 4 into bit 11~bit 8 in SR1072 (SR1172, SR1272…), and select a mode of returning home described above. Users can instruct some axes in AH20MC-5A to return home, and the others to operate in DMCNET motion modes simultaneously. The axes which are instructed to return home can not be controlled by uniaxial motion and multiaxial motion. The motion of a servo drive can be controlled only when the servo drive operates in a DMCNET motion mode. Note:

Before a servo drive is set to DMCNET motion mode, the value indicating the present position of the servo drive must be the same as the value indicating the present position of the axis specified. Before users set a DMCNET motion mode by means of a DMCNET, they have to change the value indicating the present position of the motor specified to the value stored in (SRmn33, SRmn32) by writing 35 into SR1078 (SR1178, SR1278…). (mn=10~25) Users can use the motion control function block T_DMCControllnit to initialize the servo drive specified on a DMCNET.

If users use the motion control function block T_DMCControllnit to initialize the axis specified on a DMCNET, the servo drive specified will be started, the AH500 series motion control module used will be synchronized with the servo drive specified, and the servo drive specified will operate in a synchronous control mode. Please refer to Chapter 5 for more information about the motion control function block T_DMCControllnit. 14-16