Mitsubishi — 14.6 DMCNET Motion Control

Chapter 14 DMCNET c. The motor used comes into contact with the negative limit switch specified. Mode 11: The motor used rotates clockwise. After the motor comes into contact with the negative limit switch specified, it will rotate counterclockwise. After a transition in DOG’s signal from high to low occurs, the motor will rotate counterclockwise until a transition in a Z-phase signal from low to high occurs. Mode 12: The motor used rotates clockwise. After the motor comes into contact with the negative limit switch specified, it will rotate counterclockwise.

After a transition in DOG’s signal from high to low occurs, the motor will rotate clockwise until a transition in a Z-phase signal from low to high occurs. Mode 13: The motor used rotates clockwise. After the motor comes into contact with the negative limit switch specified, it will rotate counterclockwise. After a transition in DOG’s signal from low to high occurs, the motor will rotate counterclockwise until a transition in a Z-phase signal from low to high occurs. Mode 14: The motor used rotates clockwise. After the motor comes into contact with the negative limit switch specified, it will rotate counterclockwise.

After a transition in DOG’s signal from low to high occurs, the motor will rotate clockwise until a transition in a Z-phase signal from low to high occurs.  The value in SR1078 (SR1178, SR1278…) is in the range of 17 to 30. The way in which the motor used operates when the value in SR1078 (SR1178, SR1278…) is in the range of 17 to 30 is similar to the way in which the motor used operates when the value in SR1078 (SR1178, SR1278…) is in the range of 1 to 14. If the value in SR1078 (SR1178, SR1278…) is in the range of 1 to 14, motor specified stops when a transition in a Z-phase signal from low to high occurs.

If the value in SR1078 (SR1178, SR1278…) is in the range of 17 to 30, the motor specified stops when a transition in DOG’s signal from low to high occurs.  The value in SR1078 (SR1178, SR1278…) is 33. The motor used rotates clockwise until a transition in a Z-phase signal from low to high occurs.  The value in SR1078 (SR1178, SR1278…) is 34. The motor used rotates counterclockwise until a transition in a Z-phase signal from low to high occurs.  The value in SR1078 (SR1178, SR1278…) is 35. Users can change the value which indicates the present position of the motor used to another value. 14-15